Specific Solutions

Mapvision 100% in process solutions help you take full control of your component production. Our solutions are used in the production of a wide range of welded and cast components, including side beams, front end modules (FEC, GOR), hatches, axle components, underbody modules and even entire ladder frames.

cross-car-beam-inspection-mapvision

Measurement

  • Measure every feature within 30 seconds – with no technical limit to the number of features you measure
  • Measure feature locations in 3D (x,y,z)
  • Calculate all distances, angles, etc..
  • Use 100% in-line data to accurately adjust your line
  • Get usable data for improving geometric quality from day one of pre-production
  • Double shuttle allows parallel inspection of products from two different lines

Component Checks

  • Automated component presence checks
  • Component checks, e.g. weld nut presence and clip nut orientation
  • No significant increase in inspection time
subframe-inspection-mapvision

Measurement

  • Measure every feature within 30 seconds – with no technical limit to the number of features you measure.
  • Measure feature locations in 3D (x,y,z)
  • Calculate all distances, angles, etc.
  • Use 100% in-line data to accurately adjust your line
  • Get usable data for improving geometric quality from day one of pre-production

Virtual Clamp (Exclusive to Mapvision)

  • Collect both clamped and unclamped measurement results for a full picture of your subframes.
  • No need for a mechanical clamp
  • No hardware-related problems
  • No maintenance of moving components
  • Field-tested, ideal for subframes

Component Checks

  • Automated component presence checks
  • Presence checks for weld nuts, weld studs, etc.
  • No significant increase in inspection time
twist-beam-axle-inspection-mapvision

Measurement

  • Measure every feature within 30 seconds – with no technical limit to the number of features you measure.
  • Measure feature locations in 3D (x,y,z)
  • Calculate all distances, angles, etc.
  • Use 100% in-line data to accurately adjust your line
  • Get usable data for improving geometric quality from day one of pre-production
  • Camber and toe angle measurement

Component Checks

  • Automated component presence checks
  • Component checks, e.g. weld nut presence and clip nut orientation
  • No significant increase in inspection time

Do you need more info?

icono-phone-white

34 943 84 88 89