CMM Upgrades and Retrofits
Convert your old CMM to the new digital era and give a step forward into the world of industry 4.0 it was never so simple.
Available for :
- All type of CMM
- Any manufacturer
- Multiple Sensors
- Great variety of Controllers
- The best softwares on the market
Convert your analog CMM into a digital CMM
Technology never stops
With more than 35 years of experience in the installation, training, repair, maintenance, advice and reconversion in all types of dimensional measurement equipment, we offer all our potential to make the most of your old machine to convert it into a measurement equipment with the latest developments in state-of-the-art probes, software and electronics.
It does not matter which is the kinematics of your old CMM: Mobile bridge, fixed bridge, cantilever, horizontal arm or gantry. We study its structure and modifying or maintaining its reading system, adapting it for each required configuration, we make it an updated unit.
Alliance with the best hardware and software technology providers (RENISHAW, METROLOG, POLYWORKS, KREON and PANTEC)
New CAD measurement software systems, improvements in programming methods, and new trends in the smart factory environment invite you to convert your old CMM to a fully digital equipment with the most demanded probes on the market both touch, such as 2D scanning and 3D scanning. As well as with management, analysis, reporting and highly flexible data output software.
All retrofits have an approved certification.
Greater dimensional knowledge of your part
Decision making in a smarter way
Increased effective use of the machine
Reduction of environmental impact